
Remote Control
R&S
®
ZNB/ZNBT
717
User Manual 1173.9163.02 ─ 53
VXI-11 protocol, the alternative commands @REM and @LOC can be used to switch
from manual to remote control and back.
While remote control is active, operation via the front panel is disabled except the
"Remote" softtool. The instrument settings are optimized for maximum measurement
speed; the display is switched off:
The softkeys in the remote screen are used to modify or quit the remote state:
●
"Go to Local" switches the instrument to local state.
●
"Display" switches the display on or off.
●
If a remote error message is displayed at the bottom of the remote screen, you can
use "Clear Error Messages" to delete it.
The remaining controls are for future extensions.
Display on and off states
Switching on the display means that the analyzer shows the measurement screen with
the current recall sets, diagram areas and traces without leaving the remote state. In
this operating mode, it is possible to observe the screen while a remote control script is
executed and the control elements on the front panel are still disabled.
Introduction to Remote Control