Rohde & Schwarz 1311.6010.22, User Manual

Page: 43 / 1451

Getting Started
R&S
®
ZNB/ZNBT
43 User Manual 1173.9163.02 ─ 53
Index Label Description
10 REF IN BNC input for an external reference frequency. Use this connector to synchronize
the R&S
ZNB to another device.
See Chapter 6.17.2, "Freq. Ref. Tab" , on page 687.
11 (System
drive) Contains the removable system drive of the R&S ZNB, containing all software
(including the operating system and the VNA application) and data. Do not remove
the system drive during operation.
Option R&S ZNB-B19 provides an additional removable system drive (including
operating system and firmware). See Chapter 5.7.14, "Additional Removable System
Drive" , on page 231.
12 (Ground
connector) The ground connector provides the ground of the analyzer's supply voltage. Use this
connector for ESD protection; see
"Instrument damage caused by electrostatic dis-
charge" on page 20.
Table 4-3: Optional rear panel connectors
Index Label Description
13 Bias Tees
or
RFFE -
GPIO
Interface
This slot can be equipped with one of the following options:
●
R&S ZNB-B1, "Bias Tees", providing two or four additional BNC inputs labeled
BIAS 1 ... 4 (for two-port or four-port analyzers). The inputs can be used to
apply an external DC voltage (bias) to the test ports. For fuse replacement,
refer to
Chapter 11.4.3, "Replacing Fuses" , on page 1398.
●
R&S ZN-B15 "RFFE - GPIO Interface".
25-pin female connector, providing:
–
2 independent RF Front-End (RFFE) interfaces according to the MIPI® Alli-
ance "System Power Management Interface Specification".
– 10 General Purpose Input/Output (GPIO) pins.
14 Device
Control Option R&S ZNB-B12 "Device Control" provides a PCIe and a Direct Control con-
nector.
See Chapter 5.7.11, "Device Control" , on page 229.
The Direct Control interface enables direct connections between the VNA measure-
ment bus and one or more extension devices, such as:
●
An external RFFE GPIO interface R&S ZN-Z15.
●
Switch matrices R&S ZN-Z8x.
●
Multiport calibration units R&S ZN-Z154.
15 Handler
I/O Option R&S ZN-B14, Handler I/O (Universal Interface), providing a Centronics 36
input/output connector.
See Chapter 5.7.12, "Handler I/O (Universal Interface)" , on page 229.
16 GPIB Option R&S ZNB-B10 provides a GPIB bus connector according to standard IEEE
488 / IEC 625.
See Chapter 11.3.3, "GPIB Interface" , on page 1384.
17 DC INPUT Option R&S ZNB-B81"DC Inputs" provides four BNC inputs for DC measurements
(adjustable to different voltage ranges).
See Chapter 6.2.11, "DC Tab" , on page 281.
Instrument Tour