Rohde & Schwarz 1311.6010.22, User Manual

Page: 571 / 1451

GUI Reference
R&S
®
ZNB/ZNBT
571 User Manual 1173.9163.02 ─ 53
Remote command:
CALCulate<Ch>:TRANsform:VNETworks:DIFFerential:
EMBedding<LogPt>[:STATe]
File Name 1
The ellipsis button in the "File Name 1" column is enabled if a 2-port data Network is
selected.
When loading the touchstone file (
*.s2p
), the analyzer by default assumes odd ports
left (VNA side), even ports right (DUT side). However, it is also possible to "Swap
Gates" , instructing the analyzer to reinterpret the loaded S-parameters (e.g. S
12
-->
S
21
).
Note: The loaded S-parameter traces are stored in the active recall set. Persisted
recall sets contain the full embedding and deembedding data so that they can be trans-
ferred to other instruments.
Remote command:
MMEMory:LOAD:VNETworks<Ch>:DIFFerential:EMBedding<LogPt>
6.13.2 Offset Tab
Defines length offset parameters for each port.
Use the complementary dock widget to activate or deactivate length/loss compensation
for selected ports (see
Chapter 6.13.1.2, "Offset Panel" , on page 563).
The marker function Zero Delay at Marker function overwrites the offset parameters.
Background information
Refer to the following sections.
●
Chapter 5.6, "Offset Parameters and De-/Embedding" , on page 183
●
Chapter 5.6.1.1, "Definition of Offset Parameters " , on page 183
●
Chapter 5.6.1.3, "Auto Length" , on page 184
●
Chapter 5.6.1.6, "Application and Effect of Offset Parameters " , on page 188
●
Chapter 5.6.1.7, "Offset Parameters for Balanced Ports" , on page 189
●
Chapter 5.6.1.5, "Fixture Compensation " , on page 187
Offset Embed Softtool