Rohde & Schwarz 1311.6010.22, User Manual

Page: 435 / 1451

GUI Reference
R&S
®
ZNB/ZNBT
435 User Manual 1173.9163.02 ─ 53
Step 2: Connectors and Cal Kits
Selects the connector type and gender for all ports and allows you to import a calibra-
tion kit.
Background information
Refer to Chapter 5.5.2, "Calibration Standards and Calibration Kits" , on page 160.
Messages in the dialog
An information message (or error message) is displayed if one of the following hap-
pens:
●
One of the selected calibration kits is described by ideal kit parameters or typical
values.
●
One of the selected calibration kits does not contain all standards that are required
for the previously selected calibration type.
●
Different connector types are defined at the ports but the selected calibration type
requires uniform connectors.
●
A cal kit standard does not cover the entire calibrated frequency range.
Figure 6-19: Calibration Setting Wizard, Step 2: Connectors and Cal Kits
The upper part of the panel shows the ports and the calibration type selected in Step 1:
Ports and Type . The lower part gives access to the connector and cal kit settings.
If more than 4 ports are available, the GUI is slightly different:
Cal Softtool