NXP Semiconductors freescale KV4 Series, Reference Manual

Page: 692 / 1359

ADC_RSLTn field descriptions (continued)
Field Description
The interpretation of the numbers programmed into the limit and offset registers, LOLIM, HILIM, and
OFFST should match your interpretation of the result register.
Reserved This field is reserved.
This read-only field is reserved and always has the value 0.
34.4.16 ADC Low Limit Registers (ADC_LOLIMn)
Each ADC sample is compared against the values in the limit registers. The comparison
is based upon the raw conversion value with no offset correction applied. The limit
register used corresponds to the result register the value will be written to. The high limit
register is used for the comparison of Result > High Limit. The low limit register is used
for the comparison of Result < Low Limit. The limit checking can be disabled by
programming the respective limit register with 7FF8h for the high limit and 0000h for the
low limit. At reset, limit checking is disabled.
Address: 4005_C000h base + 3Ch (2d × i), where i=0d to 15d
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Read 0
LLMT
0
Write
Reset
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
ADC_LOLIMn field descriptions
Field Description
15
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
14–3
LLMT
Low Limit Bits
Reserved This field is reserved.
This read-only field is reserved and always has the value 0.
Memory Map and Registers
KV4x Reference Manual, Rev. 2, 02/2015
692
Preliminary
Freescale Semiconductor, Inc.