NXP Semiconductors freescale KV4 Series, Reference Manual

Page: 1037 / 1359

The 100 MHz clock frequency equates to a clock period of 10 ns, so the PIT needs to
count for 6000 million cycles, which is more than a single timer can do. So, Timer 1 is
set up to trigger every 6 s (600 million cycles). Timer 2 is chained to Timer 1 and
programmed to trigger 10 times.
The value for the LDVAL register trigger is calculated as number of cycles-1, so
LDVAL1 receives the value 0x23C345FF and LDVAL2 receives the value 0x00000009.
The interrupt for Timer 2 is enabled by setting TCTRL2[TIE], the Chain mode is
activated by setting TCTRL2[CHN], and the timer is started by writing a 1 to
TCTRL2[TEN]. TCTRL1[TEN] needs to be set, and TCTRL1[CHN] and TCTRL1[TIE]
are cleared.
The following example code matches the described setup:
// turn on PIT
PIT_MCR = 0x00;
// Timer 2
PIT_LDVAL2 = 0x00000009; // setup Timer 2 for 10 counts
PIT_TCTRL2 = TIE; // enable Timer 2 interrupt
PIT_TCTRL2 |= CHN; // chain Timer 2 to Timer 1
PIT_TCTRL2 |= TEN; // start Timer 2
// Timer 1
PIT_LDVAL1 = 0x23C345FF; // setup Timer 1 for 600 000 000 cycles
PIT_TCTRL1 = TEN; // start Timer 1
Chapter 40 Periodic Interrupt Timer (PIT)
KV4x Reference Manual, Rev. 2, 02/2015
Freescale Semiconductor, Inc.
Preliminary
1037