H3C SOHO IE4300, Command Reference Manual

Page: 2867 / 3296

56
Usage guidelines
You cannot edit a reaction entry after it is created. To change the attributes in a reaction entry, use
the
undo reaction
command to delete the entry, and then configure a new one.
For the MOS threshold, the number is expressed in three digits representing ones, tenths, and
hundredths. For example, to express a MOS threshold of 1, enter 100.
Examples
# Create reaction entry 1 for monitoring the MOS value of the voice operation, and set the upper limit
to 2 and lower limit to 1. Before the NQA operation starts, the initial state of the reaction entry is
invalid. After the operation, the MOS value is checked against the threshold range. If it exceeds the
upper limit, the state of the reaction entry is set to over-threshold. If it is below the lower limit, the
state is set to below-threshold. Once the state of the reaction entry changes, a trap message is
generated and sent to the NMS.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type voice
[Sysname-nqa-admin-test-voice] reaction 1 checked-element mos threshold-value 200 100
action-type trap-only
reaction checked-element packet-loss
Use
reaction checked-element packet-loss
to configure a reaction entry for monitoring
packet loss in UDP jitter or voice operation.
Use
undo reaction
to delete a reaction entry.
Syntax
reaction item-number checked-element packet-loss threshold-type
accumulate accumulate-occurrences [ action-type { none | trap-only } ]
undo reaction item-number
Default
No reaction entries for monitoring packet loss exist.
Views
ICMP jitter/UDP jitter/voice operation view
Predefined user roles
network-admin
Parameters
item-number
: Assigns an ID to the reaction entry, in the range of 1 to 10.
threshold-type
: Specifies a threshold type.
accumulate accumulate-occurrences : Specifies the total number of lost packets in the
operation. The value range is 1 to 15000 for the ICMP jitter and UDP jitter operations and 1 to 60000
for the voice operation.
action-type
: Specifies what action to be triggered. The default action is
none
.
none
: Specifies the action of displaying results on the terminal display.
trap-only : Specifies the action of displaying results on the terminal display and meanwhile
sending SNMP trap messages to the NMS.