26
Views
Interface view
Predefined user roles
network-admin
Usage guidelines
When a link failure occurs between the local device and the specified neighbor, BFD can detect the
failure. The local device will not receive or send any RIP packets through the interface connected to
the neighbor.
The
rip bfd enable destination
command applies only to BFD echo-mode detection.
The
rip bfd enable destination
command and the
rip bfd enable
command are
mutually exclusive and cannot be configured on a device at the same time.
Examples
# Enable BFD on VLAN-interface 10 for a specific destination 202.38.165.1.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip bfd enable destination 202.38.165.1
rip default-route
Use
rip default-route
to configure a RIP interface to advertise a default route with a specified
metric.
Use
undo rip default-route
to disable a RIP interface from sending a default route.
Syntax
rip default-route
{
{
only
|
originate
}
[
cost
cost-value
|
route-policy
route-policy-name
]
*
|
no-originate
}
undo rip default-route
Default
A RIP interface advertises a default route if the RIP process that the interface runs is enabled to
advertise a default route.
Views
Interface view
Predefined user roles
network-admin
Parameters
only
: Advertises only a default route.
originate
: Advertises both a default route and other routes.
cost-value
: Specifies a cost for the default route, in the range of 1 to 15. The default is 1.
route-policy
route-policy-name
: Specifies a routing policy by its name, a case sensitive
string of 1 to 63 characters. If you specify this option, the command advertises a default route only
when a route in the routing table matches the routing policy.
no-originate
: Advertises only non-default routes.
Summary of Contents for SOHO IE4300
