H3C SOHO IE4300, Command Reference Manual

Page: 1178 / 3296

19
cannot remove the setting configured for a process by using the
import-route { ospf | rip }
process-id
command. To remove the setting for that process, you must specify the process ID in
the
undo
form of the command.
Examples
# Redistribute static routes into RIP, and set the cost of redistributed routes to 4.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] import-route static cost 4
Related commands
default cost
network
Use
network
to enable RIP on an interface attached to a specified network.
Use
undo network
to disable RIP on an interface attached to a specified network.
Syntax
network network-address [ wildcard-mask ]
undo network network-address
Default
RIP is disabled on an interface.
Views
RIP view
Predefined user roles
network-admin
Parameters
network-address : Specifies a subnet address where an interface resides.
wildcard-mask
: Specifies an IP address wildcard mask. A wildcard mask can be thought of as a
subnet mask, with 1s and 0s inverted. For example, a wildcard mask of 255.255.255.0 corresponds
to a subnet mask of 0.0.0.255. If you do not specify this argument, the command uses the natural
mask.
Usage guidelines
RIP runs only on an interface attached to the specified network, which can be configured with a
wildcard mask. An interface not on the specified network does not receive or send RIP routes, or
advertise its direct routes.
For a single RIP process, the network 0.0.0.0 command can enable RIP on all interfaces. If
multiple RIP processes exist, the command is not applicable.
If a physical interface is attached to multiple networks, you cannot advertise these networks in
different RIP processes.
Examples
# Enable RIP process 100 on the interface attached to the network 129.102.0.0.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] network 129.102.0.0