H3C SOHO IE4300, Command Reference Manual

Page: 3213 / 3296

20
Examples
# Set the minimum interval to 4 (2
2
) seconds for sending delay request messages on GigabitEthernet
1/0/1.
<Sysname> system-view
[
Sysname
]
ptp profile 1588v2
[
Sysname
]
ptp mode oc
[
Sysname
]
interface gigabitethernet 1/0/1
[
Sysname-GigabitEthernet1/0/1
]
ptp min-delayreq-interval 2
Related commands
ptp mode
ptp profile
ptp syn-interval
ptp mode
Use
ptp mode
to specify a clock node type for the device.
Use undo ptp mode to restore the default.
Syntax
ptp mode { bc | e2etc | e2etc-oc | oc | p2ptc | p2ptc-oc }
undo ptp mode
Default
No clock node type is specified.
Views
System view
Predefined user roles
network-admin
Parameters
bc
: Specifies the clock node type as boundary clock (BC).
e2etc : Specifies the clock node type as end-to-end transparent clock (E2ETC).
e2etc-oc : Specifies the clock node type as E2ETC+OC.
oc
: Specifies the clock node type as ordinary clock (OC).
p2ptc
: Specifies the clock node type as peer-to-peer transparent clock (P2PTC).
p2ptc-oc
: Specifies the clock node type as P2PTC+OC.
Usage guidelines
CAUTION:
If you change the clock node type for the device, all settings except for the PTP profile will be
removed.
This command is available only after you specify a PTP profile.
When the PTP profile is SMPTE ST 2059-2, you cannot specify the E2ETC+OC or P2PTC+OC clock
node type.