H3C SOHO IE4300, Command Reference Manual

Page: 1406 / 3296

37
Table 21 Command output
Field Description
Area ID Area ID.
Down
In this state, neighbor initial state, the router has not received any information from a
neighboring router for a period of time.
Attempt
This state is available only in an NBMA network. In this state, the OSPFv3 router has
not received any information from a neighbor for a period. The router can send Hello
packets at a longer interval to keep the neighbor relationship.
Init
In this state, the device received a Hello packet from the neighbor but the packet
contains no router ID of the neighbor. Mutual communication is not setup.
2-Way
Mutual communication between the router and its neighbor is available. DR/BDR
election is finished under this state (or higher).
ExStart
In this state, the router decides on the initial DD sequence number and active/standby
relationship of the two parties.
Exchange In this state, the router exchanges DD packets with the neighbor.
Loading In this state, the router sends LSRs to request the neighbor for needed LSAs.
Full LSDB synchronization has been accomplished between neighbors.
Total Total number of neighbors under the same state.
display ospfv3 request-queue
Use display ospfv3 request-queue to display OSPFv3 request list information.
Syntax
display ospfv3 [ process-id ] [ area area-id ] request-queue
[ interface-type interface-number ] [ neighbor-id ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
process-id
: Specifies an OSPFv3 process by its ID in the range of 1 to 65535. If you do not
specify an OSPFv3 process, this command displays OSPFv3 request list information for all OSPFv3
processes.
area area-id
: Specifies an area by its ID, an IPv4 address or a decimal integer in the range of 0
to 4294967295 that is translated into the IPv4 address format. If you do not specify an OSPFv3 area,
this command displays OSPFv3 request list information for all areas.
interface-type interface-number : Specifies an interface by its type and number. If you do
not specify an interface, this command displays OSPFv3 request list information for all interfaces.
neighbor-id : Specifies a neighbor's router ID. If you do not specify a neighbor, this command
displays OSPFv3 request list information for all OSPFv3 neighbors.
Examples
# Display OSPFv3 request list information.