H3C SOHO IE4300, Command Reference Manual

Page: 1197 / 3296

38
Usage guidelines
The
minimum-interval
and
incremental-interval
cannot be greater than the
maximum-interval
.
For a stable network, the minimum-interval setting is used. If network changes become
frequent, the incremental interval
incremental-interval
is used to extend the triggered
update sending interval until the
maximum-interval
is reached.
Examples
# For RIP process 1, set the maximum interval, minimum interval, and incremental interval to 2
seconds, 100 milliseconds, and 100 milliseconds, respectively.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] timer triggered 2 100 100
timers
Use
timers
to set RIP timers.
Use
undo timers
to restore the default.
Syntax
timers { garbage-collect garbage-collect-value | suppress suppress-value
| timeout timeout-value | update update-value } *
undo timers { garbage-collect | suppress | timeout | update } *
Default
The garbage-collect timer is 120 seconds, the suppress timer is 120 seconds, the timeout timer is
180 seconds, and the update timer is 30 seconds.
Views
RIP view
Predefined user roles
network-admin
Parameters
garbage-collect-value : Specifies the garbage-collect timer in the range of 1 to 3600
seconds.
suppress-value
: Specifies the suppress timer in the range of 0 to 3600 seconds.
timeout-value
: Specifies the timeout timer in the range of 1 to 3600 seconds.
update-value
: Specifies the update timer in the range of 1 to 3600 seconds.
Usage guidelines
RIP uses the following timers:
•
Update timer —Specifies the interval between routing updates.
•
Timeout timer —Specifies the route aging time. If no update for a route is received before the
timer expires, RIP sets the metric of the route to 16.
•
Suppress timer —Specifies how long a RIP route stays in suppressed state. When the metric
of a route becomes 16, the route enters the suppressed state. If RIP receives an update for the
route with a metric less than 16 from the same neighbor, RIP uses this route to replace the
suppressed route.