H3C SOHO IE4300, Command Reference Manual

Page: 3052 / 3296

6
cwmp cpe connect interface
Use
cwmp cpe connect interface
to specify the CWMP connection interface.
Use
undo cwmp cpe connect interface
to restore the default.
Syntax
cwmp cpe connect interface interface-type interface-number
undo cwmp cpe connect interface
Default
No CWMP connection interface is specified.
Views
CWMP view
Predefined user roles
network-admin
Parameters
interface-type interface-number
: Specifies the type and number of the CWMP
connection interface.
Usage guidelines
A CWMP connection interface is the interface that the CPE uses to communicate with the ACS. To
establish a CWMP connection, the CPE sends the IP address of this interface in the Inform
message, and the ACS replies to this IP address.
Typically, the CPE selects the CWMP connection interface automatically. If the CWMP connection
interface is not the interface that connects the CPE to the ACS, the CPE fails to establish a CWMP
connection with the ACS. For example, an incorrect CWMP connection interface selection occurs
when the following conditions exist:
•
The CPE has multiple Layer 3 interfaces.
•
The IP addresses of the CWMP connection interface and the ACS are not in the same subnet.
In this case, you need to use this command to manually specify the CWMP connection interface.
Examples
Specify VLAN-interface 2 as the CWMP connection interface.
<Sysname> system-view
[Sysname] cwmp
[Sysname-cwmp] cwmp cpe connect interface vlan-interface 2
cwmp cpe connect retry
Use cwmp cpe connect retry to set the maximum number of attempts the CPE can make to
retry a failed CWMP connection.
Use
undo cwmp cpe connect retry
to restore the default.
Syntax
cwmp cpe connect retry retries
undo cwmp cpe connect retry