15
Usage guidelines
When you create a Layer 2 aggregate interface, the system automatically creates a Layer 2
aggregation group with the same number. The aggregation group operates in static aggregation
mode by default.
Deleting a Layer 2 aggregate interface also deletes the Layer 2 aggregation group. At the same time,
the member ports of the aggregation group, if any, leave the aggregation group.
Examples
# Create Layer 2 aggregate interface Bridge-Aggregation 1, and enter its view.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1]
jumboframe enable
Use
jumboframe enable
to allow the jumbo frames on an interface to pass through.
Use
undo jumboframe enable
to deny jumbo frames on an interface.
Use
undo jumboframe enable size
to restore the default.
Syntax
jumboframe enable
[
size
]
undo jumboframe enable
[
size
]
Default
An interface allows jumbo frames with a maximum length of 10240 bytes to pass through.
Views
Layer 2 aggregate interface view
Predefined user roles
network-admin
size
: Specifies the maximum length of jumbo frames, in bytes. The value range for this argument is
1522 to 10240.
Usage guidelines
If you execute this command multiple times, the most recent configuration takes effect.
Examples
# Allow jumbo frames on Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> System-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] jumboframe enable
lacp default-selected-port disable
Use
lacp default-selected-port disable
to disable the default port selection action for
dynamic aggregation groups.
Use
undo lacp default-selected-port disable
to enable the default port selection action
for dynamic aggregation groups.
Summary of Contents for SOHO IE4300
