H3C SOHO IE4300, Command Reference Manual

Page: 1311 / 3296

110
•
You change the router ID to the address of a loopback interface after a physical interface
address is selected as the router ID.
•
A higher interface IP address is configured as the router ID.
After a router ID is changed, you must use the reset command to enable it.
Examples
# Configure a global router ID as 1.1.1.1.
<Sysname> system-view
[Sysname] router id 1.1.1.1
silent-interface (OSPF view)
Use
silent-interface
to disable an interface or all interfaces from receiving and sending
OSPF packets.
Use
undo silent-interface
to remove the configuration.
Syntax
silent-interface { interface-type interface-number | all }
undo silent-interface { interface-type interface-number | all }
Default
An interface can receive and send OSPF packets.
Views
OSPF view
Predefined user roles
network-admin
Parameters
interface-type interface-number
: Specifies an interface by its type and number.
all
: Specifies all interfaces.
Usage guidelines
To disable a network from receiving and sending OSPF routes, use the command on the interface
connected to the network.
Examples
# Disable VLAN-interface 10 from receiving and sending OSPF packets.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] silent-interface vlan-interface 10
snmp trap rate-limit
Use
snmp trap rate-limit
to set the SNMP notification output interval and the maximum
number of SNMP notifications that can be output at each interval.
Use
undo snmp trap rate-limit
to restore the default.
Syntax
snmp trap rate-limit interval trap-interval count trap-number