Omron CS1W-MCH71 -, Operation Manual

Page: 93 / 717

48
Connecting MECHATROLINK Devices
Section 3-5
Transmission settings
MECHATROLINK communications can be specified using the DIP switch
(SW1). See the table below.
Any change of the settings becomes valid after turning OFF the power once,
and then ON again.
Station address setting
Station address can be set as shown in the table below using the rotary switch
(SW2) and piano switch (SW1 bit 3).
The bit 3 of SW1 specifies the number of 10s while the SW2 specifies the
number of units.
Do not change the setting while the power is being supplied.
64-point I/O module (IO2310) connector pin layout, signal names, and
wiring example
For details, refer to YASKAWA ELECTRIC CORPORATION’s “Machine Con-
troller MP900 Series MECHATROLINK System USER’S MANUAL (MANUAL
NO. SIEZ-C887-5.1*)”.
SW1 Name Setting Content Default setting
1 Baud rate OFF 4 Mbps ON (Do not set to
OFF.)
ON 10 Mbps
2 No. of Transmitted bytes OFF 17 bytes OFF
ON 30 bytes
3 Station address OFF Refer to Station
address setting OFF
ON
--- Reserved OFF --- OFF
Bit 3 of SW1 SW2 Station address SW2 default setting
OFF 0 Do not set. 0
1 to F 1 to 15 (1 to FH)
ON 0 to F 16 to 30 (10H to 1EH)
0
1
2
3
4
5
8
F
E
D
C
B
6
7
9
A
SW2 (Default setting)