Screen Reference
Data modules
Administrator’s Guide for Avaya Communication Manager
743
November 2003
DESTINATION
CHAP
Appears when the
Type
field is ppp. Used with Point-to-Point data modules. See Administration for
Network Connectivity for Avaya Communication Manager for more information.
procr-intf
Assigns a Processor Interface Data Module. The Processor Interface data
modules are the Processor Data Modules (PDMs) that are integrated into
the system’s synchronous/asynchronous Processor Interface circuit pack
ports.
NOTE:
The Processor Interface data module is applicable only to
DEFINITY SI configurations.
They are used to provide the following interfaces:
•
3B/Call Management System (maximum of 1)
•
3B/Message Server (maximum of 1)
•
Distributed Communications System (maximum of 8)
•
AUDIX (maximum of 1)
NOTE:
Not all maximums can be achieved at the same time
Connections for these interfaces are achieved via a digital line port and
MPDM combination, and/or in the case of DCS or ISDN-PRI, via a DS1
interface. One direct EIA connection is available (labeled as Processor
Interface on the back of the Control Cabinet) for simplex operation.
When used, the physical channel assignment (see below) must be “01”.
Use of the EIA connection eliminates the need for one digital line
port/MPDM combination. See Administration for Network Connectivity
for Avaya Communication Manager for more information on Processor
Interface data modules.
system-port
Assigns a System Port Data Module.
tdm
Assigns a DTE interface for Processor/Trunk Data Modules. See the
pdm entry above.
wcbri
Assigns a World Class BRI Data Module.
x.25
Assigns an X.25 Data Module in DEFINITY R configurations for
communications to Adjuncts and other nodes in a DCS network. See
Administration for Network Connectivity for Avaya Communication
Manager for more information on X.25 data modules.
Valid entries
Usage