Ruijie RG-S29 Series, Справочник по командам

Страница: 149 / 1510

Command Reference Syslog Commands
Defaults
The buffer size is related to the specific device type.
access switches: 128 K Bytes;
The log severity is 7.
Command
Mode Global configuration mode
Usage Guide The memory buffer for log is used in recycled manner. That is, when the memory buffer with the
specified size is full, the oldest information will be overwritten. To show the log information in the
memory buffer, run the show logging command in privileged user mode.
The logs in the memory buffer are temporary, and will be cleared in case of device restart or the
execution of the clear logging command in privileged user mode. To trace a problem, it is required
to record logs in flash or send them to Syslog Server.
The log information is classified into the following 8 levels (Table 1):
Table-1
Keyword Level Description
Emergencies 0
Emergency case, system cannot run
normally
Alerts 1 Problems that need immediate remedy
Critical 2 Critical conditions
Errors 3 Error message
warnings 4 Alarm information
Notifications 5
Information that is normal but needs
attention
informational 6 Descriptive information
Debugging 7 Debugging messages
Lower value indicates higher level. That is, level 0 indicates the information of the highest level.
When the level of log information to be displayed on devices is specified, the log information at or
below the set level will be allowed to be displayed.
After running the system for a long time, modifying the log buffer size especially in condition of
large buffer may fails due to the insufficent availble continuous memory. The failure message
will be shown. It is recommended to modify the log buffer size as soon as the system starts.
Configuration
Examples
The following example allows logs at and below severity 6 to be recorded in the memory buffer sized
10,000 bytes.
Ruijie(config)# logging buffered 10000 6
Related
Commands
Command Description
logging on Turns on the log switch.