Ruijie RG-S29 Series, Справочник по командам

Страница: 795 / 1510

Command Reference OSPFv3 Commands
Usage Guide
RGOS supports three authentication modes:

null authentication mode, which is configured when authentication is not needed

MD5 authentication mode

SHA1 authentication mode
OSPFv3 authentication parameters configured on interconnected interfaces must be consistent.
Configuration
Examples
The following example specifies MD5 authentication in OSPFv3 interface configuration mode and
sets the authentication password to aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa.
Ruijie(config-if)# ipv6 ospf authentication ipsec spi 300 md5
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
Related
Commands
Command Description
ipv6 ospf authentication
Specifies interface authentication.
area virtual-link authentication Specifies virtual link authentication.
Platform
Description
N/A
3.20 ipv6 ospf cost
Use this command to set the cost of the interface. Use the no form of this command to restore the
default setting
ipv6 ospf cost cost [ instance instance-id ]
no ipv6 ospf cost [ instance instance-id ]
Parameter
Description
Parameter Description
Cost Cost of interface, in the range from 0 to 65535.
instance instance-id
Configures the specific OSPFv3 instance on the interface, in the
range from 0 to 255.
Defaults The default interface cost is the reference bandwidth/Bandwidth (100Mbps by default).
Command
Mode
Interface configuration mode.
Usage Guide By default, the cost of the OSPFv3 interface is 100Mbps/Bandwidth, in which the Bandwidth is the
bandwidth of the interface and configured with the command bandwidth in the interface configuration
mode.
The default costs of OSPFv3 interfaces for several typical lines are:

64K serial line: 1562;