Ruijie RG-S29 Series, Справочник по командам

Страница: 1111 / 1510

Configuration Guide Port Security Commands
rate-limit rate
Indicates the printing rate of binding filter logging. The default rate is
10logs/minute. The configurable range is from 1 to 120 logs per
minute.
Defaults By default, binding filter logging is disabled.
Command
Mode
Global configuration mode
Usage Guide 1. If you run the switchport port-security binding-filter logging command without configuring the
rate parameter, binding filter logging is enabled and the default printing rate, 10logs/minute, is
adopted.
2. After binding filter logging is enabled, for packets that do not comply with IP/IP-MAC binding,
warmings are printed.
3. After binding filter logging is enabled, if the printing rate exceeds the configured rate, the number of
suppressed packets is displayed.
Configuration
Examples
The following example enables binding filter logging.
Ruijie# configure terminal
Ruijie(config)# switchport port-security binding-filter logging
Ruijie(config)# end
Related
Commands
Command Description
N/A N/A
Platform
Description
N/A
9.6 switchport port-security interface binding
Use these commands to configure secure address binding manually in the privileged EXEC mode
through performing the source IP address plus source MAC address binding or only the source IP
address binding. With this binding configured, only the packets match the binding secure address
could enter the switch, others will be discarded.
Use the no form of these commands to remove the binding addresses.
switchport port-security interface i nterface-id binding [ mac-address vlan vlan_id ]
｛
ipv4-address
| ipv6-address
｝
switchport port-security interface interface-id binding
｛
ipv4-address | ipv6-address
｝
no switchport port-security interface i nterface-id binding [ mac-address vlan vlan_id ]
｛
ipv4-address | ipv6-address
｝
no switchport port-security interface interface-id binding
｛
ipv4-address | ipv6-address
｝
Parameter Parameter Description