Ruijie RG-S29 Series, Справочник по командам

Страница: 525 / 1510

Command Reference IPv6 Commands
Defaults The default is 0. (The maximum number is the neighbor table size supported by the device)
Command
Mode
Global configuration mode
Usage Guide This command is used to prevent unresolved ND table entries generated by malicious scan attacks
from consuming table entry resources,
Configuration
Examples
The following example sets the maximum number of the unresolved neighbor table entries to 200.
Ruijie(config)# ipv6 nd unresolved 200
Related
Commands
Command Description
N/A N/A
Platform
Description
N/A
3.24 ipv6 neighbor
Use this command to configure a static neighbor. Use the no form of this command to delete a static
neighbor.
ipv6 neighbor ipv6-address interface-id hardware-address
no ipv6 neighbor ipv6-address interface-id
Parameter
Description
Parameter Description
ipv6-address
The neighbor IPv6 address, in the form as defined in
RFC4291.
interface-id
Specifies the network interface where the neighbor is
(including Router Port, L3 AP port and SVI interface).
hardware-address
The 48-bit MAC address, a dotted triple of four-digit
hexadecimal numbers.
Defaults No static neighbor is configured by default.
Command
Mode
Global configuration mode
Usage Guide This command can only be configured on the interface enabled with IPv6 protocol, similar to the ARP
command.
If the neighbor to be configured has been learned through Neighbor Discovery Protocol (NDP) and
stored in the NDP neighbor table, the dynamic neighbor turns to be static. If the static neighbor is
valid, it is always reachable. An invalid static neighbor refers to the neighbor whose IPv6 address is
not valid (not in the IPv6 network segment configured for the interface or interface address conflict).