Ruijie RG-S29 Series, Справочник по командам

Страница: 801 / 1510

Command Reference OSPFv3 Commands
which ranges from 0 to 255.
Defaults No neighbor is defined;
Neighbor polling interval: 120 seconds;
Priority value of non-broadcast network neighbor: 0.
Command
Mode Interface configuration mode.
Usage Guide You can set relevant parameters for the neighbors depending on the actual network type.
Configuration
Examples
The following example shows how to configure the OSPFv3 neighbor as follows: IPv6 address:
2001:DB8:4::1, priority value: 1, polling interval: 150 seconds.
Ruijie(config)# interface fastEthernet 0/1
Ruijie(config-if)# ipv6 ospf neighbor 2001:DB8:4::1 priority 1 poll-interval
150
Related
Commands
Command Description
Ipv6 ospf priority
Sets the priority value of an interface.
Ipv6 ospf network Sets the network type of an interface.
Platform
Description
N/A
3.26 ipv6 ospf network
Use this command to set the network type of the interface. Use the no form of this command to
restore the default setting.
ipv6 ospf network { broadcast | non-broadcast | point-to-point | point-to-multipoint
[ non-broadcast ] } [ instance instance-id ]
no ipv6 ospf network [ broadcast | non-broadcast | point-to-point | point-to-multipoint
[ non-broadcast ] ] [ instance instance-id ]
Parameter
Description
Parameter Description
broadcast Specifies the broadcast network type.
non-broadcast Specifies the non-broadcast network type.
point-to-point Specifies the point-to-point network type.
point-to-multipoint Specifies the point-to-multipoint network type.
point-to-multipoint
non-broadcast
Specifies the point-to-multipoint non-broadcast network type.
instance instance-id Configures the specific OSPFv3 instance on the interface with the