Ruijie RG-S29 Series, Справочник по командам

Страница: 1223 / 1510

Configuration Guide NFPP Commands
Command
Mode
NFPP configuration mode
Usage Guide
When the attacker is detected, if the isolate period is 0, the attacker will be monitored by the software
and the timeout time will be the monitor period. During the software monitoring, if the isolate period is
not 0, the software-monitored attacker will be auto-isolated by the hardware and the timeout time will
be the isolate period. The monitor period is valid with the isolate period 0.
If the isolate period has changed to be 0, the attackers on the interface will be removed rather than
being monitored by the software.
Configuration
Examples
The following example sets the monitor time to 180 seconds.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# dhcpv6-guard monitor-period 180
Related
Commands
Command Description
show nfpp dhcpv6-guard summary Displays the configuration.
show nfpp dhcpv6-guard hosts Displays the monitored host list.
clear nfpp dhcpv6-guard hosts
Clears the isolated host.
Platform
Description
N/A
21.33 dhcpv6-guard rate-limit
Use this command to set the rate-limit threshold globally.
Use the no or default form of this command to restore the default setting.
dhcpv6-guard rate-limit { per-src-mac | per-port } pps
no dhcpv6-guard rate-limit { per-src-mac | per-port }
default dhcpv6-guard rate-limit { per-src-mac | per-port }
Parameter
Description
Parameter Description
per-src-mac Sets the rate limit for each source MAC address.
per-port
Sets the rate limit for each port.
pps Sets the rate limit, in the range from 1 to 19,999.
Defaults The default value varies with products. For details, see the Configuration Guide .
Command
Mode
NFPP configuration mode