Hitachi SJ Series, User Manual

Page: 695 / 786

21-24
Chapter 21 Technical Notes
SJ700D / SJ700B SJ-P1
Remarks
Display code Function name New code
b040 Torque limit selection bA110 Addition of individual settings for second control
b041
Torque limit 1 (Four-quadrant mode normal
powered)
bA112 Addition of individual settings for second control
b042
Torque limit 2 (Four-quadrant mode reverse
regenerative)
bA113 Addition of individual settings for second control
b043
Torque limit 3 (Four-quadrant mode reverse
powered)
bA114 Addition of individual settings for second control
b044
Torque limit 4 (Four-quadrant mode normal
regenerative)
bA115 Addition of individual settings for second control
b045 Torque LADSTOP selection bA116 Addition of individual settings for second control
b046 Selection of reversal prevention HC114 Addition of individual settings for second control
b050
Instantaneous power failure non-stop
selection
bA-30
b051
Instantaneous power failure non-stop
starting voltage
bA-31
b052
Instantaneous power failure non-stop
OV-LADSTOP level (target voltage level)
bA-32
b053
Instantaneous power failure non-stop
deceleration time
bA-34
b054
Instantaneous power failure non-stop
deceleration start range
bA-36
b055
Instantaneous power failure non-stop
proportional gain setting
bA-37
b056
Instantaneous power failure non-stop
integrated time setting
bA-38
b060 Window comparator O upper limit CE-40
b061 Window comparator O lower limit CE-41
b062 Window comparator O hysteresis width CE-42
b063 Window comparator OI upper limit level CE-43
b064 Window comparator OI lower limit level CE-44
b065 Window comparator OI hysteresis width CE-45
b066 Window comparator O2 upper limit level CE-46
b067 Window comparator O2 lower limit level CE-47
b068 Window comparator O2 hysteresis width CE-48
b070 O operation level at disconnection CE-50
b071 OI operation level at disconnection CE-52
b072 O2 operation level at disconnection CE-54
b078 Deletion of integrated power UA-12
b079 Integrated power display gain UA-13
b082 Starting frequency Hb130 Addition of individual settings for second control
b083 Carrier frequency bb101 Addition of individual settings for second control
b084 Selection of initialization Ub-01
b085 Initialization data selection Ub-02
b086 Frequency conversion coefficient Ab-01
b087 Stop key selection AA-13
b088 Free-run stop selection bb-40
b089 Automatic carrier reduction bb103 Addition of individual settings for second control
b090 BRD use rate bA-60
b091 Stop mode selection AA115 Addition of individual settings for second control
b092 Cooling fan operation selection bA-70
b095 BRD selection bA-61
b096 BRD on level bA-62
b098 Thermistor selection Cb-40
b099
Thermistor error level bb-70