Hitachi SJ Series, User Manual

Page: 136 / 786

10-1
Chapter 10 Test Run
Contents
10.1 What This Chapter Explains ........................ 10-1
10.2 Let’s Check the Procedures
Before Test Runs ! ....................................... 10-2
10.3 Settings and Commands Required
for Running the Inverter ................................ 10-3
10.4 Let’s Configure Settings for Test Runs! ....... 10-4
10.4.1 To perform test runs via operator keypad
VOP ...................................................... 10-4
10.4.2 Running by attaching a variable resistor
tab to the terminal block [FW] input, H,
Ai1, and L ............................................. 10-6
10.4.3 Supplement ........................................... 10-7
10.5 Checking in the simulation mode ................. 10-8
10.1 What This Chapter Explains
This chapter provides an operational flow to do a test
run.
For method for using the operator keypad VOP, see
“Chapter 10.4.1 Operation Using the Operator
Keypad VOP” and “Chapter 9 Operating Instructions”.
Furthermore, to do a test run not via the operator
keypad VOP, configure the setting by referring to
“Chapter 11 Examples of Settings by Operation
Command Destination”.
Before conducting a test run, make sure to carefully
read “Chapter 1 Safety Instructions/Risks” for safety
work.
Symbol Meanings
General and
troubleshooting questions
Key points for a solution
Notes
Confirmation of procedures
Q
A
!
▼
10
Chapter 10 Test Run