Hitachi SJ Series, User Manual

Page: 194 / 786

12-5-7
Chapter 12
Inverter Functions
12.5.8 Temporary change of operation
command destination
• Want to make operation from the operator keypad
temporarily.
• Want to make operation from the terminal block
input temporarily.
• When 023 [F-OP] terminal is ON, the command
destination of [CA-71] is employed in a priority to
the operation command destination given in
[AA111].
Parameters
• When 023 [F-OP] terminal is ON, the frequency
command destination also employs the frequency
command selection designated in [CA-70].
• If [AA111] and [CA-71] are set differently from each
other, the operation is interrupted when the [F-OP]
terminal is made ON or OFF. The selected
operation command is enabled when it is made
OFF and then ON.
Item Parameters Data Description
Input terminal function
selection
[CA-01]~[CA-11] 023 [F-OP]: Gives a forced command.
Frequency command
selection with [F-OP]
enabled.
[CA-70] 01~15
01: Ai1-L input, 02: Ai2-L input, 03: Ai3-L input,
04: Ai4-L input, 05: Ai5-L input, 06: Ai6-L input,
07: parameter setting, 08: RS485
communication, 09:option 1, 10: option 2, 11:
option 3, 12: pulse string input (main body), 13:
pulse string input (optional) 14: program
function EzSQ, 15: PID
arithmetic
Operation command
selection with [F-OP]
enabled.
[CA-71] 00~06
00: [FW]/[RV] terminal, 01: 3 wire, 02: RUN key
on operator keypad, 03: RS485
communication, 04: option 1, 05: option 2, 06:
option 3
Ｑ
Ａ
！