Suzuki GA413, Руководство по обслуживанию

Страница: 983 / 1246

HOW TO REGISTER IGNITION KEY
Register the ignition key with a built-in transponder in Immobilizer
Control Module by using the following procedure.
1) Prepare SUZUKI scan tool and cartridge for immobilizer control
system.
2) With ignition switch OFF, connect SUZUKI scan tool to data link
connector (DLC) located on underside of instrument panel at
driver’s seat side.
(A): 09931-76011 (SUZUKI scan tool)
(B): Immobilizer cartridge
(C): 09931-76030 (16/14 pin DLC cable)
NOTE:
For operation procedure of SUZUKI scan tool, refer to SU-
ZUKI scan tool operator’s manual.
1. Data link connector (DLC)
3) Prepare ignition key with a built-in transponder. And then turn
ignition switch ON by using it.
4) Number of Transponder codes for ignition key with a built-in
transponder that can be registered in Immobilizer Control Mod-
ule is limited to 4. If needed, clear all Transponder codes for igni-
tion key with a built-in transponder that have been registered in
Immobilizer Control Module by executing the “CLR. TRANS
COD (CLEAR TP CODE)” command in the SELECT MODE
menu by using SUZUKI scan tool.
NOTE:
When “CLR. TRANS COD (CLEAR TP CODE)” command is
executed with the malfunction indicator lamp (if not
equipped with immobilizer indicator lamp) ON or the immo-
bilizer indicator lamp ON, it remains ON even after execu-
tion of that command is over. It will start flashing when the
ignition switch is turned OFF once and then turned ON after
some seconds.
1. Ignition key with built-in transponder
2. Key knob
8G-24 IMMOBILIZER CONTROL SYSTEM (IF EQUIPPED)
GA413
supple