Suzuki GA413, Руководство по обслуживанию

Страница: 64 / 1246

ON-VEHICLE SERVICE
CAUTION:
When refrigerant line must be disconnected and connected to remove and reinstall any component
of A/C system, be sure to observe following instructions.
When disconnecting any line from system, install a blind plug or cap to fitting of such line immedi-
ately.
When connecting hoses and pipes to each other respectively, previously apply a few drops of re-
frigerating oil to seats of coupling nuts and O-ring.
When tightening or loosening a fitting, use two wrenches, one for turn and the other for support.
Tighten flared nuts according to following specifications.Tightening torque for coupling nut
8 mm pipe: 13 N·m (1.3 kg-m, 9.5 lb-ft)
14.5mm pipe: 32 N·m (3.2 kg-m, 23.0 lb-ft)
A/C CONDENSER ASSEMBLY
INSPECTION
Check the following.
Condenser fins for leakage, blockage and damage
Condenser fittings for leakage
Clogged condenser fins should be washed with water, and should
be dried with compressed air.
NOTE:
Be careful not to damage condenser fins. If condenser fin is
bent, straighten it by using a screwdriver or pair of pliers. If
any leakage is found from fitting or tube, repair or replace con-
denser.
1. A/C condenser assembly (RHD vehicle)
2. A/C condenser assembly (LHD vehicle)
3. Receiver/dryer
A/C CONDENSER COOLING FAN MOTOR
INSPECTION
Check continuity between each two terminals.
If check results are continuity, proceed to next operation check.
If not , replace.
1. A/C condenser fan motor coupler
1B-10 AIR CONDITIONING