Suzuki GA413, Руководство по обслуживанию

Страница: 530 / 1246

DISASSEMBLY
1) Remove B terminal inner nut and insulator.
2) Remove rear end cover.
3. B terminal inner nut
1. Rear end cover
2. Insulator
3) Remove 2 screws and pull out brush holder assembly.
4) Remove 3 screws and IC regulator.
5) Remove brush holder cover from brush holder.
1. IC regulator screws
2. IC regulator 3. Brush holder screws
4. Brush holder assembly
6) Remove rectifier holder.
1. Rectifier holder
7) Hold shaft by using hexagonal box wrench and remove pulley
nut, and then pull out pulley.
CAUTION:
To hold shaft, use hexagonal box. Duodecimal box
may cause slipping and consequential shaft or tool
damage.
Do not attempt to hold pulley by using vise or pipe
wrench so as not to distort it.
8) Remove 2 rear end frame nuts and bolts.
9) Drive out rear end frame with rotor tapping shaft lightly by us-
ing plastic hammer.
10) Separate rear end frame from rotor evenly by using plastic
hammer.
CAUTION:
Do not hit shaft at slip ring side, when separating ro-
tor and rear end frame.
1. Rear end frame
2. Rotor shaft 3. Rear end frame nut
CHARGING SYSTEM 6H-15