Suzuki GA413, Руководство по обслуживанию

Страница: 798 / 1246

6-22 ENGINE GENERAL INFORMATION AND DIAGNOSIS
GA413
supple
ENGINE BASIC INSPECTION
This check is very important for troubleshooting when ECM has detected no DTC and no abnormality has been
found in visual inspection.
Follow the flow table carefully.
STEP ACTION YES NO
1 Was “ENGINE DIAG. FLOW TABLE” performed? Go to Step 2. Go to “ENGINE
DIAG. FLOW
TABLE”.
2 Check battery voltage.
Is it 11 V or more?
Go to Step 3. Charge or replace
battery.
3 Is engine cranked? Go to Step 4. Go to “DIAGNOSIS”
in Section 6G.
4 Does engine start? Go to Step 5. Go to Step 7.
5 Check idle speed as follows:
1) Warm up engine to normal operating temp.
2) Shift transmission to neutral position.
3) All of electrical loads are switched off.
4) Check engine idle speed with scan tool.
See Fig. 1.
Is it 700 – 800 r/min?
Go to Step 6. Go to “ENGINE
DIAGNOSIS TABLE”.
6 Check ignition timing as follows:
1) When not using SUZUKI scan tool, disconnect scan
tool from DLC and connect test switch terminal of moni-
tor coupler to ground. See Fig. 2.
When using SUZUKI scan tool, select “MISC” mode on
SUZUKI scan tool and fix ignition timing to initial one.
See Fig. 3.
2) Open the engine service hole cover behind the front
seats and remove the inspection hole cap on the trans-
mission case to observe ignition timing.
3) Using timing light (1), check initial ignition timing.
See Fig. 4.
Is it 5
_
3
_
BTDC at specified idle speed?
Go to “ENGINE
DIAGNOSIS
TABLE”.
Check ignition control
related parts referring
to Section 6F.
7 Check immobilizer system malfunction as follows (if
equipped):
1) Check MIL (malfunction indicator lamp) for flashing.
Is it flashing when ignition switch is turned to ON position?
Go to “DIAGNOSIS”
in Section 8G.
Go to Step 8.
8 Check fuel supply as follows:
1) Check to make sure that enough fuel is filled in fuel
tank.
2) Turn ON ignition switch for 2 seconds and then OFF.
See Fig. 5.
Is fuel return pressure (returning sounds) felt from fuel feed
hose (1) when ignition switch is turned ON?
Go to Step 10. Go to Step 9.
9 Check fuel pump for operating.
1) Was fuel pump operating sound heard from fuel filler for
about 2 seconds after ignition switch ON and stop?
Go to “DIAG. FLOW
TABLE B-3”.
Go to “DIAG. FLOW
TABLE B-2”.