Suzuki GA413, Руководство по обслуживанию

Страница: 1124 / 1246

3. Socket with adapter
7E-14 7DIFFERENTIAL (FRONT)
11) With new pinion spacer inserted as shown, install front bearing
to differential carrier.
NOTE:
D
Make sure to use new spacer for reinstallation.
D
Apply oil to bearings.
12) Drive in oil seal (1) into differential front carrier (2) till it becomes
flush with carrier end by using special tool.
Then apply grease to oil seal lip.
Special Tool
(A): 09913-85210
“ A ” : Grease 99000-25010
13) While tightening flange nut gradually with special tool and pow-
er wrench, set preload of pinion to specification.
Special Tool
(A): 09930-40113
NOTE:
D
Before taking measurement with torque wrench, check
for smooth rotation by hand.
D
Bearing preload can be measured roughly by rotating
companion frange (2) with torque wrench (1) about 1
rotation per 2 seconds.
D
Be sure to tighten gradually and carefully till specified
starting torque is obtained. Turning back overtightened
flange nuts should be avoided.
Pinion bearing preload: 0.5 – 1.3 N
.
m
(5.0 – 13.0 kg-cm, 4.3 – 11.3 lb-in.)
D
As a reference, tightening torque for flange nut should
be within following specification.
Tightening Torque
(a): 70
– 250 N
.
m (7 – 25 kg-m, 50.5 – 181 lb-ft)