Suzuki GA413, Руководство по обслуживанию

Страница: 889 / 1246

If necessary, regrind crankshaft journal and select under-size
bearing to use with it as follows.
1) Regrind journal to following finished diameter.
Finished diameter: 44.732 – 44.750 mm
(1.7611 – 1.7618 in.)
2) Using micrometer, measure reground journal diameter.
Measurement should be taken in two directions perpendicu-
lar to each other in order to check for out-of-round.
3) Using journal diameter measured above and alphabets
stamped on mating surface of cylinder block, select an un-
dersize bearing by referring to table given below.
Check bearing clearance with newly selected undersize
bearing.
Green & Red
Black & Red
Red only
Black & Red
Red only
Yellow & Red
Red only
Yellow & Red
Blue & Red
A
B
C
Measured journal diameter
Alphabet stamped
on mating surface
of cylinder block
Undersize bearing to be installed
44.744 – 44.750 mm
(1.7616 – 1.7618 in.)
44.738 – 44.744 mm
(1.7613 – 1.7616 in.)
44.732 – 44.738 mm
(1.7611 – 1.7613 in.)
Rear Oil Seal
Carefully inspect oil seal for wear or damage. If its lip is worn or
damaged, replace it.
1. Rear oil seal
For oil seal installation, press-fit rear oil seal so that oil seal housing
end face is flush with oil seal end face.
1. Oil seal
2. Oil seal housing
ENGINE MECHANICAL 6A-11
GA413
supple