Suzuki GA413, Руководство по обслуживанию

Страница: 749 / 1246

14) Separate the two banana plugs on the deployment harness.
15) Connect the deployment harness to the power source (12 V
vehicle battery) to immediately deploy the air bag.
16) Disconnect the deployment harness from the power source
(12 V vehicle battery) and short the two deployment harness
leads together by fully seating one banana plug into the other.
17) Put on a pair of shop gloves to protect your hands from pos-
sible irritation and heat when handling the deployed air bag (in-
flator) module.
18) Disconnect the deployment harness from the air bag (inflator)
module as soon after deployment as possible.
This will prevent damage to the deployment harness due to
possible contact with the hot air bag (inflator) module. The de-
ployment harness are designed to be reused. They should,
however, be inspected for damage after each deployment and
replaced if necessary.
19) Carefully remove drop cloth from vehicle and clean off any
fragments or discard drop cloth entirely.
20) Repeat Steps 2) through 19) to deploy air bag (inflator) mod-
ules which has not been deployed, if any.
21) In the unlikely event that the air bag (inflator) module proceed
immediately with Steps 23) through 25). If the air bag (inflator)
module did deploy, proceed with Steps 22).
22) With air bags deployed the vehicle may be scrapped in the
same manner as a non-air bag system equipped vehicle.
23) Remove the undeployed air bag (inflator) module(s) from the
vehicle. For driver air bag (inflator) module refer to REMOVAL
of DRIVER AIR BAG (INFLATOR) MODULE in SECTION 3C,
for passenger air bag (inflator) module (if equipped) refer to
REMOVAL of PASSENGER AIR BAG (INFLATOR) MODULE
in this section.
24) Temporarily store the air bag (inflator) module with its vinyl trim
cover facing up, away from the surface upon which it rests. Re-
fer to SERVICE PRECAUTIONS in this section for details.
25) Contact your local distributor for further assistance.
1. Stretch it to full length 10m (33 ft).
2. Power source (12V vehicle battery)
3. Connect one banana plug to positive terminal of power
source (12V vehicle battery) and then the other to negative
terminal to immediately deploy.
4. Short harness leads after deployment.
5. Drop cloth, blanket or similar them.
AIR BAG SYSTEM 10B-55