Suzuki GA413, Руководство по обслуживанию

Страница: 218 / 1246

FLUID PRESSURE TEST (if equipped with
LSPV)
Test procedure for LSPV assembly is as follows.
Before testing, confirm the following.
Fuel tank is filled with fuel fully.
Vehicle is equipped with spare tire, tools, jack and jack handle.
1) Install pressure gauges to front and rear brake.
NOTE:
Pressure gauge should be connected to bleeder plug hole
of front (driver’s side brake) and rear brakes.
Special Tool
(A) : 09956-02310
(B) : 55473-82030 (Bleeder plug (10 mm) supplied as a
spare part)
(C) : 09952-46520 (Attachment for rear wheel cylinder)
NOTE:
Special tool (C) is used instead of thread diameter 10mm
attachment included in special tool (A). So remove the at-
tachment from (A) and install (C) for pressure gauge used
for rear brake. For front brake caliper, install special tool (A)
without changing its attachment.
1. Air bleeder plug
2. Weight
3. Attachment
2) Place weight (about 90 – 130 kg (200 – 285 Ib)) slowly on rear
floor (axle housing center) so that rear axle weight is measured
as specified.
Depress brake pedal gradually till fluid pressure of front brake
becomes as specified below and check corresponding pres-
sure of rear brake then. It should be within specification given
below.
Front brake line pressure “P
1
” : 10,000 kPa
(100 kg/cm
2
, 1,422psi)
Rear axle weight “L” : 550 kg (1,213 Ib)
As done above, add weight (about 250 kg (550Ib)) so that rear
axle weight is as specified, and check that rear brake pressure
is within specification as given below.
Rear axle weight “L” : 800 kg (1,764 Ib)
5-22 BRAKES
Rear brake “P
2
”
VAN model
4,000 – 5,400 kPa
40 – 54 kg/cm
2
569 – 768 psi
TRUCK model
4,900 – 6,300 kPa
49 – 63 kg/cm
2
697 – 896 psi
Rear brake “P
2
”
VAN model
5,300 – 6,700 kPa
53 – 67 kg/cm
2
754 – 953 psi
TRUCK model
5,900 – 7,300 kPa
59 – 73 kg/cm
2
839 – 1,038 psi