Suzuki GA413, Руководство по обслуживанию

Страница: 539 / 1246

MAINTENANCE
At every interval of periodic maintenance service, and
when vehicle is raised for other service, check exhaust
system as follows:
Check rubber mountings for damage, deterioration
and out of position.
Check exhaust system for leakage, loose connec-
tion, dent and damage.
If bolts or nuts are loosened, tighten them to speci-
fied torque. Refer to “ON VEHICLE SERVICE” for
torque data.
Check nearby body areas for damaged, missing, or
mispositioned part, open seam, hole, loose connec-
tion or any other defect which could permit exhaust
fumes to seep into vehicle.
Make sure that exhaust system components have
enough clearance from underbody to avoid over-
heating and possible damage to passenger
compartment carpet.
Any defect should be fixed at once.
ON-VEHICLE SERVICE
Refer to Section 6A for removal and installation pro-
cedures of exhaust manifold.
For replacement of exhaust pipe, muffler or any part
used to mount or connect them, be sure to hoist ve-
hicle and observe WARNING given at the left of this
page.
When exhaust manifold is removed, check seals for
deterioration or damage.
Tighten bolts and nuts to specified torques when
reassembling. Refer to figure below for location of
bolts and nuts.
Tightening Torque
(a): 50 N
.
m (5.0 kg-m, 36.5 lb-ft)
(b): 40 N·m (4.0 kg-m, 29.0 lb-ft)
WARNING:
To avoid danger of being burned, do not
touch exhaust system when system is hot.
Any service on exhaust system should be
performed when system is cool.
CAUTION
As exhaust pipe has three way catalytic
converter in it (if equipped), it should not
be exposed to any impulse. Be careful not
to drop it or hit it against something.
6K-2 EXHAUST SYSTEM