Suzuki GA413, Руководство по обслуживанию

Страница: 718 / 1246

10B-24 AIR BAG SYSTEM
DTC B1016:
STEP ACTION YES NO
1 1) With ignition switch OFF, disconnect pas-
senger air bag (inflator) module connec-
tor behind the glove box.
2) Check proper connection to passenger
air bag (inflator) module at terminals in
“D” connector.
3) If OK then connect Special Tool (B) to
passenger air bag (inflator) module con-
nector disconnected at the step 1).
4) With ignition switch ON, is DTC B1016
current?
Go to step 2. 1) Ignition switch OFF.
2) Replace passenger air
bag (inflator) module (Re-
fer to PASSENGER AIR
BAG (INFLATOR) MOD-
ULE in this section).
2 1) With ignition switch OFF, disconnect
SDM.
2) Check proper connection to SDM at ter-
minals “A7” and “A8”.
3) If OK then measure resistance between
“A7” and “A8” terminals with connected
Special Tool (B).
4) Is resistance 1.4 or more?
Substitute a known-good
SDM and recheck.
Repair short from “Y” wire
circuit to “Y/R” wire circuit or
from “Y” or “Y/R” wire circuit
to other wire circuit.
Fig. for STEP 1 and 2
Fig. for STEP 2
Special Tool
(A): 09932-76010
(B): 09932-75010
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Clear diagnostic trouble codes (Refer to DTC CLEARANCE), if any.
3) Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.