Suzuki GA413, Руководство по обслуживанию

Страница: 214 / 1246

BLEEDING BRAKES
NOTE:
Before performing bleeding operation, make sure that ABS
warning light turns off after ignition switch has turned on (for
vehicle equipped with ABS).
Bleeding operation is necessary to remove air whenever it entered
hydraulic brake system.
Hydraulic lines of brake system consists of two separate lines, one
for front wheel brakes and the other for rear wheel brakes. When
a brake pipe or hose was disconnected at the wheel, bleeding op-
eration must be performed at both ends of the line of the removed
pipe or hose. When any joint part of the master cylinder of other
joint part between the master cylinder and each brake (wheel) was
removed, the hydraulic brake system must be bled at right and left
brake caliper, left wheel cylinder and LSPV (if equipped).
CAUTION:
Brake fluid is extremely damaging to paint. If fluid should
accidentally touch painted surface, immediately wipe
fluid from paint and clean painted surface.
1. Master cylinder
2. 4-way joint
3. 4-way cross joint
4. ABS actuator
5. LSPV
6. Blend proportion-
ing valve
7. Right brake caliper
8. Left brake caliper
9. Right wheel cylinder
10. Left wheel cylinder
[A] : Without ABS
[B] : With ABS
1) Fill master cylinder reservoir with brake fluid and keep at least
one-half full of fluid during bleeding operation.
2) Remove bleeder plug cap.
Attach a vinyl tube to bleeder plug, and insert the other end into
container.
1. Plug cap
2. Vinyl tube (See-through tube)
3. Container
3) Depress brake pedal several times, and then while holding it de-
pressed, loosen bleeder plug about one-third to one-half turn.
Depress brake pedal several times and with pedal
depressed, loosen bleeder plug a little.
4) When fluid pressure in the cylinder is almost depleted, retighten
bleeder plug.
5) Repeat this operation until there are no more air bubbles in hy-
draulic line.
With brake pedal depressed,
retighten bleeder plug.
5-18 BRAKES