Suzuki GA413, Руководство по обслуживанию

Страница: 336 / 1246

Cam Wear
Using a micrometer, measured height of cam. If measured height
is below limit, replace camshaft.
Camshaft Runout
Hold camshaft between two “V” blocks, and measure runout by us-
ing a dial gauge.
If runout exceeds the limit, replace camshaft.
Runout limit: 0.10 mm (0.0039 in.)
Camshaft Journal Wear
Check camshaft journals and camshaft housings for pitting,
scratches, wear or damage.
If any malcondition is found, replace camshaft or cylinder head with
housing. Never replace cylinder head without replacing housing.
1. Camshaft housing
Check clearance by using gaging plastic.
The procedure is as follows.
1) Clean housing and camshaft journals.
2) Install camshaft to cylinder head.
3) Place a piece of gaging plastic the full width of journal of cam-
shaft (parallel to camshaft).
4) Install camshaft housing, referring to page 6A-33.
5) Tighten camshaft housing bolts in such order as indicated in fig-
ure a little at a time till they are tightened to specified torque.
Tightening Torque
(a): 11 N
.
m (1.1kg-m, 8.0 lb-ft)
NOTE:
Do not rotate camshaft while gaging plastic is installed.
6A-30 ENGINE MECHANICAL
Cam height Standard Limit
Intake cam
36.184 – 36.344 mm
(1.4246 – 1.4308 in.)
36.084 mm
(1.4206 in.)
Exhaust cam
35.900 – 36.060 mm
(1.4134 – 1.4197 in.)
35.800 mm
(1.4094 in.)