Suzuki GA413, Руководство по обслуживанию

Страница: 717 / 1246

AIR BAG SYSTEM 10B-23
DIAGNOSTIC FLOW TABLE
DTC B1015:
STEP ACTION YES NO
1 1) With ignition switch OFF, disconnect passen-
ger air bag (inflator) module connector be-
hind the glove box.
2) Check proper connection to passenger air
bag (inflator) module at terminals in “D” con-
nector.
3) If OK then connect Special Tool (B) to pas-
senger air bag (inflator) module connector
disconnected at the step 1).
4) With ignition switch ON, is DTC B1015 cur-
rent?
Go to step 2. 1) Ignition switch OFF.
2) Replace passenger
air bag (inflator) mod-
ule (Refer to PAS-
SENGER AIR BAG
(INFLATOR) MOD-
ULE in this section).
2 1) With ignition switch OFF, disconnect SDM.
2) Check proper connection to SDM at termi-
nals “A7” and “A8”.
3) If OK then measure resistance between “A7”
and “A8” terminals with connected Special
Tool (B).
4) Is resistance 4.5 or less?
Substitute a known-good
SDM and recheck.
Repair high resistance or
open in “Y” or “Y/R” wire
circuit.
Fig. for STEP 1 and 2
Fig. for STEP 2
Special Tool
(A): 09932-76010
(B): 09932-75010
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Clear diagnostic trouble codes (Refer to DTC CLEARANCE), if any.
3) Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.