Suzuki GA413, Руководство по обслуживанию

Страница: 845 / 1246

ENGINE GENERAL INFORMATION AND DIAGNOSIS 6-69
GA413
supple
INSPECTION
STEP ACTION YES NO
1 Was “ENGINE DIAG. FLOW TABLE” performed? Go to Step 2. Go to “ENGINE
DIAG. FLOW
TABLE“.
2 Is there DTC other than Fuel system (DTC P0171 / P0172) and
misfire (DTC P0300-P0304)? Go to applicable
DTC Diag. Flow
Table. Go to Step 3.
3 Check Ignition System.
1) Remove spark plugs and check them for;
D
Air gap: 1.0 – 1.1 mm (0.040 – 0.043 in.) See Fig. 1.
D
Carbon deposits/Insulator damage/Plug type
If abnormality is found, adjust, clean or replace by referring
to Section 6F.
2) Disconnect all injector connectors.
3) Connect spark plugs to high tension cords and then ground
spark plugs.
4) Crank engine and check that each spark plug sparks.
Are above check results satisfactory?
Go to Step 4. Check ignition
system parts
(Refer to Section
6F).
4 Check Fuel Pressure (Refer to Section 6E for details).
1) Release fuel pressure from fuel feed line.
2) Install fuel pressure gauge. See Fig. 2.
3) Check fuel pressure.
With fuel pump operating
and engine at stop
: 270 – 310 kPa, 2.7 – 3.1 kg/cm
2
,
38.4 – 44.0 psi.
At specified idle speed : 210 – 260 kPa, 2.1 – 2.6 kg/cm
2
,
29.8 – 37.0 psi.
Is measured value as specified?
Go to Step 5. Go to Diag. Flow
Table B-3 fuel
pressure check.
5 Check Fuel Injectors and Circuit.
1) Using sound scope (1) or such, check operating sound of
each injector (2) when engine is running. Cycle of operating
sound should very according to engine speed.
See Fig 3.
If no sound or an unusual sound is heard, check injector
circuit (wire or coupler) or injector.
2) Turn ignition switch OFF and disconnect a fuel injector
connector.
3) Check for proper connection to fuel injector at each terminal.
See Fig. 4.
4) If OK, then check injector resistance.
Injector Resistance: 10 – 15 ohm at 20
_
C (68
_
F)
5) Carry out steps 1) and 3) on each injector.
6) Check each injector for injected fuel volume referring to
Section 6E. See Fig. 5.
Injected Fuel Volume: 43 – 47 cc/15 sec (1.45/1.51 –
1.58/1.65 US/Imp. oz/15 sec)
7) Check each injector for fuel leakage after injector closed.
Fuel Leakage: Less than 1 drop/min.
Is check result in step 1) and 3) to 7) satisfactory?
Go to Step 6. Check injector
circuit or replace
fuel injector(s).