Suzuki GA413, Руководство по обслуживанию

Страница: 183 / 1246

6) Install differential carrier assembly, refer to Section 7F.
7) Install wheel speed sensor harness clamps (if equipped with
ABS).
8) Connect brake pipes onto axle housing and clamp them se-
curely.
For clamping positions, refer to Section 5 of this manual.
9) Connect brake flexible hose to bracket on axle housing and
secure it with E-ring.
1. E-ring
2. Flexible hose
10) Connect brake pipe to brake flexible hose and tighten brake
pipe flare nut to specified torque.
Tightening Torque
(a): 16 N·m (1.6 kg-m, 11.5 lb-ft)
11) Perform steps 4) to 13) of REAR AXLE SHAFT INSTALLA-
TION in this section.
12) Attach LSPV stay to axle housing for vehicle with LSPV.
13) Lower hoist.
14) Tighten trailing arm front and rear nuts (coil spring type), shock
absorber lower nut to specified torque.
Tighten lateral rod nuts to specified torque (Coil spring type).
NOTE:
When tightening these nuts, be sure that vehicle is off
hoist and in non loaded condition.
Tightening Torque
(a): 80 N·m (8.0 kg-m, 58.0 lb-ft)
15) Check to ensure that brake drum is free from dragging and
proper braking is obtained.
16) If equipped with LSPV, check and adjust LSPV spring, refer to
LSPV INSPECTION AND ADJUSTMENT and perform FLUID
PRESSURE TEST in Section 5.
Perform brake test (foot brake and parking brake).
(For brake test, see Section 5.)
17) Check each installed part for oil leakage. 1. Shock absorber
2. Lateral rod
3. Trailing arm
REAR SUSPENSION 3E-19