Suzuki GA413, Руководство по обслуживанию

Страница: 105 / 1246

DTC CHECK
USING SUZUKI SCAN TOOL
1) Turn ignition switch to OFF position.
2) After setting cartridge to connect it to data link connector (DLC)
located on underside of instrument panel at driver’s seat side.
Special Tool
(A): 09931-76011
(B): Mass storage cartridge
(C): 09931-76030
3) Turn ignition switch to ON position.
4) Read DTC according to instructions displayed on SUZUKI scan
tool and print it or write it down. Refer to SUZUKI scan tool oper-
ator’s manual for further details.
5) After completing the check, turn ignition switch to OFF position
and disconnect SUZUKI scan tool from data link connector
(DLC).
1. Data link connector (DLC)
NOT USING SUZUKI SCAN TOOL
1) Check that MIL (“EPS” light) comes ON when ignition switch is
turned to ON position.
If it does not come “ON”, proceed to Table A- MIL CIRCUIT
CHECK (MIL DOES NOT LIGHT).
2) Apply chocks to wheels, set shift lever to neutral position and
pull parking brake fully.
3) Start engine.
4) Using service wire, short diagnosis switch terminal and ground
terminal on monitor coupler.
5) Read DTC from flashing pattern of MIL (“EPS” light). (Refer to
DTC TABLE.)
If it cannot indicate flashing pattern of DTC, proceed to Table C
-MIL CIRCUIT CHECK (MIL REMAINS ON).
6) After completing the check, turn ignition switch to OFF position
disconnect service wire from monitor coupler.
1. Monitor coupler
2. Diagnosis switch terminal
3. Ground terminal
ELECTRICAL POWER STEERING (P/S) SYSTEM 3B1-7