Avaya Octel 50, Руководство по установке

Страница: 94 / 304

Setting Up the System Configuring System Setup Parameters
Octel 50 Installation Guide 8-34
Related Parameters/Features The Delay for Busy In Minutes determines how long the
Octel 50 system waits between retries for attempts resulting
in a busy.
If the Number of Retries for No Answer is reached first, the
Octel 50 system places the message in the sender’s new
message queue and makes no further attempts.
Each time the Number of Retries for Busy is reached for a
message and the Octel 50 system returns the message to
the sender’s mailbox, an attempt is counted towards
Maximum Number of Attempts Before Failure.
If Set Too High The Octel 50 system may unnecessarily tie up a port trying
to reach a remote system that may be down.
If Set Too Low The Octel 50 system may unnecessarily return messages to
subscriber mailboxes. If set to 0, the Octel 50 system places
the message in the sender’s mailbox after the first attempt
resulting in a busy.
Min
0
Max
99
Default
5
Requires
Restart
No
Switch-
Dependent
No
Set by
Integrator
No
AMIS Parameters - #54
Delay for No
Answer In
Minutes
This parameter defines the number of minutes the Octel 50
system waits between retries when dispatching to a remote
access phone number that does not answer. This parameter
applies to all outbound network messaging (Administered
AMIS, Casual AMIS, network replies).
When/How to Use The default for this parameter should be sufficient for most
Octel 50 systems.
Related Parameters/Features This parameter determines the delay between Number of
Retries for No Answer.
If Set Too High The higher you set this parameter, the longer it will take for
the message to reach its intended destination
If Set Too Low The lower you set this parameter, the faster the Octel 50
system exhausts the number of retries.
Min
3
Max
99
Default
5
Requires
Restart
No
Switch-
Dependent
No
Set by
Integrator
No
AMIS Parameters - #55
Number of
Retries for No
Answer
This parameter defines the number of no answer responses
the Octel 50 system allows when attempting dispatch to a
remote access phone number. This parameter applies to all
outbound network messaging (Administered AMIS, Casual
AMIS, network replies).
When/How to Use The default for this parameter should be sufficient on most
Octel 50 systems.