Avaya Octel 50, Руководство по установке

Страница: 124 / 304

Setting Up the System Configuring System Setup Parameters
Octel 50 Installation Guide 8-64
Message Waiting Light Parameters
The Message Waiting Light parameters specify how the Octel 50 system activates and
deactivates message waiting lights for the switch. All the Message Waiting Light
parameters are set when the Integrator utility is run.
Message Waiting Light Parameters - #118
Permit Message
Waiting Lights
This parameter enables and disables the Message Waiting
Light feature for the Octel 50 system.
When/How to Use This parameter is set when the Integrator utility is run, if
your switch supports the Message Waiting Light feature.
Related Parameters/Features
If this parameter is turned off, the other Message Waiting
Light parameters are not available.
Message Waiting Lights must be enabled in the subscriber’s
class of service.
If Use Communications Message Waiting Light Software
(COMMMWL) is enabled, the Permit Message Waiting
Lights parameter must be on.
If Set Too High Not applicable.
If Set Too Low Not applicable.
Min
–
Max
–
Default
No
Requires
Restart
No
Switch-
Dependent
Yes
Set by
Integrator
Yes
Message Waiting Light Parameters - #119
Message Waiting
Light Prefix ON
Code
This parameter specifies the code the Octel 50 system must
insert at the beginning of the dialing string to turn a
message waiting light on.
When/How to Use This parameter is set when the Integrator utility is run, if
required by the switch.
Related Parameters/Features Some switches require both a prefix code and a suffix code.
When Integrator is run, the Octel 50 system sets both of
these parameters, if required.
If Use Communications Message Waiting Light Software
(COMMMWL) is enabled, the Message Waiting Light Prefix
ON Code must be left blank.
The minimum and maximum for this parameter refer to the
length of the entry allowed, not an actual value.
If Set Too High Not applicable.
If Set Too Low Not applicable.