Avaya Octel 50, Руководство по установке

Страница: 105 / 304

Setting Up the System Configuring System Setup Parameters
Octel 50 Installation Guide 8-45
Call Queuing Parameters - #85
Number of
Seconds for
First Caller in
Queue to Wait
This parameter specifies the number of seconds the Octel
50 system waits after attempting to transfer the first caller in
a queue to the desired extension before attempting to
transfer them again.
When/How to Use For most Octel 50 systems, the default setting should be
sufficient. Increase this value if you want callers to remain
on hold longer between prompt voicing.
Related Parameters/Features None.
If Set Too High
Callers may assume they have been disconnected and
hang up.
If Set Too Low Not applicable; the default is the minimum allowed setting.
Min
1
Max
99
Default
1
Requires
Restart
No
Switch-
Dependent
No
Set by
Integrator
No
Intercom Paging Parameters
The Intercom Paging parameters define the codes the Octel 50 system dials to activate
the Intercom Paging feature. They also determine how many times and how often the
Octel 50 system pages a subscriber.
Intercom Paging Parameters - #86
Intercom Paging
Code
This parameter specifies the dialing string the Octel 50
system must send to the switch to activate Intercom Paging.
When the Octel 50 system initiates a page, it puts the caller
on hold, dials the Intercom Paging Code, then returns to the
caller.
When/How to Use This parameter is set when the Integrator utility is run, if
required by the switch.
The minimum and maximum for this parameter refer to the
length of the entry allowed, not an actual value.
Related Parameters/Features If you want to configure zone paging, enter the zone paging
code for each mailbox in the Number field under Intercom
Paging on the Subscriber Settings dialog box. This code
overrides the Intercom Paging code.
If Set Too High Not applicable.
If Set Too Low Not applicable.
Min
0
Max
15
Default
Blank
Requires
Restart
No
Switch-
Dependent
Yes
Set by
Integrator
Yes