Avaya Octel 50, Руководство по установке

Страница: 54 / 304

Configuring Dial Plan Identifying Local Area Code and Prefixes
Octel 50 Installation Guide 6-2
Identifying Local Area Code and Prefixes
Use the following procedure to identify the local area code and associated prefixes for the
Octel 50 system.
To configure the Dial Plan utility during Octel 50 installation:
1. During installation, after the Octel 50 program files and SMDI utility are installed, the
Octel 50 Dial Plan Utility dialog box displays.
2. Press any key to continue. If previous Dial Plan information exists, you are prompted
whether to load the information. Select Yes if you want to display the existing
information or No to continue without displaying the existing information. The Local
Telephone Information dialog box displays.
3. Enter the local area code in the Area Code field at the top of the dialog box.
4. Press the down arrow key to move to the first prefix field, and enter a prefix
associated with the area code you entered. You can enter 3 digits to represent a 3-
digit prefix, 4 digits to represent a 1 plus a 3-digit prefix, or 6 digits to represent an
area code plus a 3-digit prefix.
If the first 3 digits in a 6-digit string are the same as the specified local area code, Dial
Plan prompts you whether you want to convert the data to a 3-digit prefix.
5. Repeat step 4 until you identify all prefixes for the local area code. If you are entering
a list of sequential prefixes, once you enter the first, you can press the <1> key
(forward slash) to enter the previous 1.
6. To save the configuration and exit the Dial Plan utility, use the arrow or <TAB> keys
to highlight the Done button, then press <ENTER>.
To activate Dial Plan, enable the Use Dial Plan parameter in System Setup. If Use Dial
Plan is not selected, Dial Plan dials 1 before all 10-digit outdial sequences.
Running Dial Plan After Installation
You can set up or edit Dial Plan settings after you install the Octel 50 system by running
Dial Plan as a standalone utility. To run Dial Plan, from the \CVR prompt, type
DIALPLAN
then press <ENTER>.
If you encounter a memory problem when running Dial Plan, unload the board drivers by
typing, from the \CVR prompt,
RDSPEXIT
for Rhetorex or
RELEASE
for Dialogic then
pressing <ENTER>.