Avaya Octel 50, Руководство по установке

Страница: 247 / 304

Testing and Troubleshooting the Octel 50 System Using the Command Line Interface
O
CTEL
50 I
NSTALLATION
G
UIDE
13-45
Activating and Deactivating Digit Grabber
Use the following procedures to activate and deactivate the digit grabber utility. When
debug is enabled, digits sent by the switch display on the Command Line interface.
To activate digit grabber:
1. Press <ESC> to close the active display and active the menu bar.
2. Select Command Line from the Display menu.
3. From the Command Line, type
DIGRAB ON
then press <ENTER>.
To deactivate digit grabber:
1. Press <ESC> to close the active display and active the menu bar.
2. Select Command Line from the Display menu.
3. From the Command Line, type
DIGRAB OFF
then press <ENTER>.
Disabling and Enabling Ports
Use the following procedures to disable and enable system ports. When you use the
disable command, the port is disabled at the completion of the current call and no further
calls are accepted.
To disable a port:
1. Press <ESC> to close the active display and active the menu bar.
2. Select Command Line from the Display menu.
3. From the Command Line, type
DIS
n then press <ENTER> where n is the
number of the port you want to disable. For example, to disable the first port, from the
Command Line, type
DIS 0
then press <ENTER>.
4. To disable all ports, type DIS ALL then press <ENTER>.
To free all ports, first use the DIS command to prevent unoccupied ports from
answering further calls, then use DROP to terminate calls on any occupied lines.
To enable a port:
1. Press <ESC> to close the active display and active the menu bar.
2. Select Command Line from the Display menu.
3. From the Command Line, type ENA n then press <ENTER> where
n
is the number
of the port you want to enable. For example, to enable the first port, from the
Command Line, type
ENA 0
then press <ENTER>.