Avaya Octel 50, Руководство по установке

Страница: 118 / 304

Setting Up the System Configuring System Setup Parameters
Octel 50 Installation Guide 8-58
Call Waiting Parameters
The Call Waiting parameters determine how the Octel 50 system dispatches call waiting
attempts. Call waiting notifies the subscriber of another incoming call when the subscriber
is on the line by sounding a tone over the subscriber’s handset or intercom. Call waiting is
a system-wide feature and cannot be activated or deactivated for individual mailboxes.
When Enable Automated Attendant is disabled, Call Waiting is not available.
Call Waiting Parameters - #108
Call Waiting
Code
This parameter determines the code the Octel 50 system
dials to instruct the switch to activate call waiting.
When/How to Use The minimum and maximum for this parameter refer to the
length of the entry allowed, not an actual number.
Related Parameters/Features The Octel 50 system dials the Transfer Prefix or the Custom
Transfer Code, if defined, to transfer the call to the desired
extension. If the extension is busy, the Octel 50 system
places the call on hold, then dials the Call Waiting Code to
activate the call waiting feature.
If Set Too High Not applicable.
If Set Too Low Not applicable.
Min
0
Max
32
Default
Blank
Requires
Restart
No
Switch-
Dependent
Yes
Set by
Integrator
No
Call Waiting Parameters - #109
Number of
Attempts for Call
Waiting
This parameter specifies the number of times the Octel 50
system attempts to notify a subscriber of an incoming call
before returning to the call with a busy or no answer
condition.
When/How to Use Set this parameter to a value greater than 0 if you want to
use Call Waiting.
Related Parameters/Features None.
If Set Too High The Octel 50 system ports activating call waiting are tied up
for Call Waiting instead of calls.
If Set Too Low Not applicable; the default value is the minimum allowed for
this parameter. Set this parameter to 0 to disable call
waiting.
Min
0
Max
9
Default
3
Requires
Restart
No
Switch-
Dependent
No
Set by
Integrator
No
Call Waiting Parameters - #110
Release Code for
Call Waiting
This parameter determines the code the Octel 50 system
dials to retrieve the call from hold after the call waiting is
activated.