Avaya Octel 50, Руководство по установке

Страница: 5 / 304

FCC Part 15 Requirements
The components of the Octel 50 system described in this manual have been deemed to
comply with FCC Part 15.
Octel 50 equipment has been tested and found to comply with the limits for Class B
computing devices in accordance with the specifications in Subpart J of Part 15 of the
FCC rules. These specifications are designed to provide reasonable protection against
interference.
Some telephone companies require you to notify them if you connect electronic
communications equipment to the telephone lines. Provide the telephone company with
the FCC registration and Ringer Equivalence Numbers (REN). The sum of the RENs from
all equipment on one phone line must be less than 5. Note that the Octel 50 ringer
equivalence is approximately 0.5.
FCC Part 68 Requirements
The components of the Octel 50 system described in this manual have been deemed to
comply with the requirements of Part 68 of the FCC rules. Octel 50 equipment has a label
that contains the FCC registration and Ringer Equivalence Numbers (RENs) for the
board.
Some telephone companies require you to notify them if you connect electronic
communications equipment to the telephone lines. Provide the telephone company with
the FCC registration and Ringer Equivalence Numbers. The sum of the RENs from all
equipment on one phone line must be less than 5. Note that the Octel 50 ringer
equivalence is approximately 0.5.
The REN is used to determine the number of devices you can connect to the telephone
line and still be assured that all of those devices ring properly when the number is called.
In most areas, the sum of the RENs of all devices should not exceed 5. To be certain of
the number of devices you may connect to the line as determined by the RENs, call the
local telephone company and request information on the maximum REN for the calling
area.
The local telephone company must be notified prior to installation that you are connecting
a registered device to the phone system. You must also provide the following information
to the telephone company for it to select the correct type of service for its lines:
•
Service type: Loop Start or Ground Start—see paragraph 4.1 of the Configuration
Note for the switch
•
Jack required: Multiple RJ-14
•
Order in which you want incoming lines to be when they are connected to the
jacks
•
Ringer Equivalence Number: 0.5A
The telephone company may make changes in its technical operation or procedures. If
these changes affect the use of this equipment, the telephone company is required to
provide you advance notice.