Toshiba VP 300, Installation Instructions Manual

Page: 359 / 614

HARD DISK PROCEDURES
This section describes the procedures used for restoring, replacing, adding, and removing a hard disk drive.
The procedures to Upgrade Languages is described for systems at Release 7.1 or later. This section also
describes the hard disk drive utility programs used while performing the hard disk procedures.
■
Preparation
The following equipment is needed for the Hard Disk Procedures and should be assembled and
verified prior to starting.
•
Hard disk drive(s) to be used for replacement.
•
Release L.5.X.X Software Diskettes (two diskettes), Release L.6.X.X, or Release 7.X.X Software
Diskettes (two diskettes).
•
Release L.5.X.X System Prompt Diskettes (four diskettes), Release L.6.X.X, or Release L.7.X.X
System Prompt Diskettes.
•
A terminal and printer (or terminal with hardcopy capability) for communicating with the VP 300
and for obtaining a printed copy of all system inputs and responses.
☞
This is important for troubleshooting and recovery if errors are reported during execution
of the procedures.
■
Procedures
☞
A separate subsection for Release 5.3 and prior and for Release 6.1 and later is included
for each of these procedures.
The Hard Disk Procedures included in this section are:
RESTORE To restore a system to operation when system drive(s) must be replaced or the
software is to be updated. Refer to Hard Disk Restore in this section.
REPLACE To replace a disk drive in a multiple-drive system. Refer to Hard Disk Replace
in this section.
ADD
To add a drive to a system. Refer to Hard Disk Add in this section.
REMOVE
To remove a drive from a multiple-drive system. Refer to Hard Disk Remove in
this section.
UPGRADE To expand the disk area to allow two languages, or to reallocate the prompt area
LANGUAGE to handle one large size language. Refer to Upgrade Languages in this section.
(Release 7.1 or later).
☞
When Upgrade Language is performed, the voice storage capacity on
the hard drive is decreased by approximately 30 minutes.
■
Commands
The utility programs used while performing the hard disk procedures are:
•
DSKMAP
•
DSKTST
•
DISKO
Toshiba VP Systems Release 7.1 July, 1994
PROCEDURES
6-45
6.6